Search results

Last ride of the year I seen 117 mph on hard pack..

Who's kit did you go with?.

So the speedo's are like 5 mph off?. As most manufactures.

So whats the top speed on your recall?. I got 103 mph last week on a rail road bed then let off because of poor visibility. Think I will save it for the lake. She was still pulling!..

I put the lighter ones on the wifes 600 sba a couple weeks ago. The stock spring had 3/4 in of sag with her on it. The light .347 had 1 1/34 in sag and she 130 lbs w/o gear .The setting was low. Just wondering I jumped on it at 285 lbs and the sag was 3 3/4. Skid not broke in yet 0 miles. We...

BMP has a dyno sheet on there site with there 660cc bb kit showing the upgrade of the 660cc kit over stock... looks like on there dyno 125 hp.

I put mine on the top of the side panel, with the assault stock black wind shield I don't think it would be there long. If you look at the pic above from Burr600xc I put mine at a angle right were the "if" is on his post. If the dnr doesn't like it then I'm back to square one with you. I did...

That's sounds pretty close to what I had in her 600 doo. Ran 42srt, 2mm o/s rollers, 130/290 in primary with 412 ramps and 16.5 grams. Ill have to look at the manual, I think I remember the 600 sba has like a 1.88 gear ratio already. I remember it was more than the 800.

Really a doo oil cap, cool. Brock, I have done most my clutching in the past and have a buddy that does a ton of doo clutching and works for his cuz at the doo doctor sled /trans shop. My problem lately is my job. Work has blown up and I leave at 8am and get home at 8pm or later and I'm burned...

Brock, if your offering I would be very grateful for a copy. tkjab@yahoo.com thanks tom

OK, summer over starting to work on are two new sba's. I was told by the lady I still owe are account $2k from the buy of the sleds, I just sold her last sled. So it looks like no real mods this year, just accessories and set up. So I warmed up the paypal account this weekend, heres what I got...

So I'm just curious, this year will be are first year on poo's. After reading a bunch of posts on several web sites it seems maybe woodys studs are like a Polaris brand sensitive thing?. Nobody talks of stud boy, bad or good. I have ran stud boys on are doo's with great luck with a lot higher...

Try MCB performance here in Michigan, online. I cant seem to find them cheaper and the prices are with nuts and your choice of backers.

So can the lower thermostat be used in the 2017 or is the ecm set up for opt running at 125 degrees?.

Not to be a smart azz, but its not a stocker anymore.

Yeah, I mixed a little in my doo rs860 to lube the intake side of the piston. Only have 200 miles on my 800 sba. Still looking for a place to mount a oil caddy.

What about the 600 I picked up for wife?.. Same rings?. Dealer dumped a quart in tank.

Nice!!!. Did you send the crank out too or just top end?.

Brock, do you port your own cylinders or do you send them out?. Why do you think it cracked?. Heat and opening the ports up?.

I just drain all but 2 gallons out of my sled with non ethanol 91 octane. Pour with my ratio mixing container in 25:1 oil, couple oz of k-100 and run it til warm, run it up a little and shut it down. Plenty of oil. I do keep them in the garage and start them once or twice a summer. Fill them in...