Recent content by Ru4real

This year I’m running the following Gearing 23T 40B with 70P chain. Quite a bit more chain dogleg compared to last years setup of 24T 40B with 70P. Primary spring Team white 120-310. Last year I ran the stock gold 100-275. Secondary switched to 48-44 helix using stock 123-203 spring. Still...

Good info.

Put the stock secondary spring back in 123/203 and kept the 48-42 track on the helix. My other helix track is 48-44. You were right about the pull. Pulls way harder than 155/222 spring.

This is purely a guess. I think you can replace it and go, based on other PWM stepper motor applications I'm familiar with.

With the amount and variance of codes, it's possible the PWM converter is shot. Good choice on looking for a Digital wrench hookup.

Lost hole shot to a studded 15 INDY 800. 2016 Rush Pro-S 800R running my 2017 spring setup left in sled, just because, which is 70 pitch chain with 40B and 24T gears for 1.67 ratio. 155-222 secondary spring team black. Helix 46-42. Stock primary spring, 70gram EPI Belly Buster weights. Balanced...

From experience, they can be a bugger to figure out. Is it an electric start sled? Batteries can mask bad grounds and suck up the extra voltage. For non-battery sleds, the grounds must all be good for the voltage regulator to work. I've even had to cut lugs off wires, strip wires back to...

Hard to tell from the first photo, but I'm thinking it was machined there because I can see machining marks in the trac. The cover bushing looks normal to me.

Studded? I went with 6" shaper bars.

Voltage regulator is shot, based on what you wrote.

I used shrink tube as well. But I think this method would be even better because the fiber material has better heat insulating properties, thus less heat into the bars.

Yes, I'm running a stock pipe.

Put on 90 miles today. 210 total for the year so far. 13F outside and this sled was pulling 8400RPM all day long. Stock original spring and 70 gram weights. I could pull 72's. Does that seem odd for a stock pipe?

Thank you for the info. Hopefully you will get some snow soon!

Swapped PTO side motor mounts front to back today. The back one was visibly worn, it's now in front. The front one looked pretty good, now in back. I will have to order new mounts. I think someone over on HCS has ones with stiffer rubber. Has anyone tried those new motor mounts? Where to get...