Recent content by Pro S

May as well replace all 5 at this point. Thanks again

Looks like the Napa Ar606 relay is similar

I remember in the past pulling all the relays and putting die electric grease on all of them... I will check them out. Thanks for all the responses

Is the load shed relay in the 5 pin black rectangular relay in the velcro bag near the clutch cover? Similar to the 2 relays on the front cross member?

Hi guys. I have a 2017 Switchback Pro S 800. The heated grips seem to not work very well. Not much heat almost seems as though the heat comes and goes. They don't start to get warm until sixteen or seventeen miles into the trip. The grips used to get so long. I could never run them on high, now...

So far I had 6 inch snow trackers and 108 studs I think-2 in each row. When cornering at a aggessive speed the sled wants to push straight through the corners. Can not seem to plant a ski and turn like its on rails. So far these are my specs. I weigh 205lbs, FTS 1 1/8 clickers both on 4 from...

Perfect thanks again ill give this a go!

Great thanks ill try this. Are the measurements on the shocks the exposed threads under the large nut or is it measured differently?

Yes studded with 2 in each row. Are your clickers on your shocks set low? Mine are in the center but thinking the Spring tension is more of the issue?

Hi guys, just wondering what everyone has for a suspension set up to rail the corners. I have A 2017 Switchback Pro S LE. It seems to not corner real well and push when you try to turn. I weigh about 205, What's a good set up to run for Spring tension and clicks on the shocks. Thanks for the help.

I know this is an older thread but was wondering where the measurements are exactly taken. Like FTS 1 1-1/8?? I have 500 ish miles on my 17 pro s and am trying to get it to corner good. U sure where to set this b.s. for a 200lb ish rider. Thanks

Hi. Just wondering is anyone is running Snow Trackers for carbides and if you have better results setting the tow per manual at 1/8 toe out or at 0 per instructions for snow trackers? Thanks